I replaced the screen on my Kobo Clara hd recently after it broke; by far the hardest part was removing the old screen from the glue holding it on to the metal plate. Apparently newer models are much easier to repair.
Also, while you have it open (in fact, go and open it just to do this!), replace the internal SD card; they have a tendency to fail; my ereader had been getting very annoying with lag and random reboots until I did this, now runs like a dream. You'll need to copy your old sd card across or find an image somewhere (they exist on some forums) if it's too far gone (I got the bulk of my using DD rescue but there was a _lot_ of errors)
The housings are not sealed. At least not on the older Aura H2O models. That model's water proofing achieved by a coating on the PCB. I googled this in a panic when a significant amount of water came flowing from the USB port as I removed it from the bath.
I replaced the screen on my Kobo Clara hd recently after it broke; by far the hardest part was removing the old screen from the glue holding it on to the metal plate. Apparently newer models are much easier to repair.
Also, while you have it open (in fact, go and open it just to do this!), replace the internal SD card; they have a tendency to fail; my ereader had been getting very annoying with lag and random reboots until I did this, now runs like a dream. You'll need to copy your old sd card across or find an image somewhere (they exist on some forums) if it's too far gone (I got the bulk of my using DD rescue but there was a _lot_ of errors)
The H2O model is water tight. Is there anything about seal on the outer shell to take care of?
The housings are not sealed. At least not on the older Aura H2O models. That model's water proofing achieved by a coating on the PCB. I googled this in a panic when a significant amount of water came flowing from the USB port as I removed it from the bath.